TermCrimp Tool and Die-R59/RG6

• Professional tool incorporating a single frame with several interchangeable dies
• Full cycle ratchet with safety release
• High-quality electrical and mechanical crimps are made simultaneously
• Crimps meet or exceed industry standards
• Assures a positive mechanical and electrical crimp and ease of use
• Crimping dies can be easily switched with two screws
The die will slide out towards the front of the frame simply by loosening the two socket head screws and removing them.
To replace the die
1. Simply extend the frame to its full open position.
2. Close the frame approximately halfway.
3. Insert the die into the frame until it stops. All dies can be inserted only one way for the tool to close properly.
4. Tighten the screws approximately halfway.
5. Close the frame to press the dies against each other. This helps to align the dies in the frame.
6. Finish tightening the screws.
7. Frame and tool are complete and ready for use.